Evezor Alpha Robotic Arm

The goal has always been to create the most capable robotic arms and the most competitive prices. And while these arms are amazing and can do all the things we've posted on our youtube channel the price point was still dramatically higher than we were hoping for.

Finish what you started. We are finally offering these now to get them in the hands of people who want to play with amazing robots and to take part in our journey

The price is set basically at materials cost. In every way the manufacture of our first batch would be considered a complete financial loss. This sale is less an attempt to recover costs as getting hardware into the hands of people because we're now at a point where we're ready to take the next steps and have a software and hardware stack that is exciting enough to share. All funds received will be directed toward more development and getting more people involved.

With your purchase you will receive one beta robot arm immediately and another of our (still to be named) robotic arms that will be featured in an upcoming Crowd Supply crowdfunding campaign. Your delivery will be either still during the campaign or on of the first deliveries just after. The later time is a decision made more by you than a requirement.

We also have a Ton of products in development and you will be on the short list to try new products and have more say on the direction of new development.

These first arms are extremely overbuilt in many ways. They each weigh over 50 pounds and are very capable. With that said further development on this style arm will be halted.

Electronics and software used to run these arms is the same software that will be in the next generation arms and will be compatible with all electronics we have yet to release.

• ESP32 microcontroller with 4MB spiram
• Runs Micropython
• 3 DRV8825 stepper motor drivers
• 2 AS5048B 14-bit absolute encoders
  • each with neopixel ring
  • allows for low/ no motion homing
  • collaborative programming
• CNC controller powered by Fluid NC with dedicated FTDI and reset switch
• Micro-sd slot
• Wifi enabled
• Canbus interface
• 24V power supply included

Extend the capabilities of your robot with all Edge Boards.
Add sensors, lights, actuators and more to increase the capabilities of your robot.
Create custom toolheads and more.